Chuck Levin's is an authorized dealer of Audio Technica

Chuck Levin's is an authorized dealer of Audio Technica

Audio-Technica PRO 35 Wired Clip-on Instrument Microphone

    Designed for sax, toms, brass and percussion, the PRO 35 excels in high-SPL applications and is ideal for active stage performances. Its extended frequency response captures subtle nuances of the performance. The included UniMount® clip permits accurate positioning and provides shock resistance while protecting the element. The microphone’s cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source.

    ELEMENT: Fixed-charge back plate, permanently polarized condenser
    POLAR PATTERN: Cardioid
    FREQUENCY RESPONSE: 50-15,000 Hz
    LOW FREQUENCY ROLL-OFF: 80 Hz, 18 dB/octave
    OPEN CIRCUIT SENSITIVITY: -45 dB (5.6 mV) re 1V at 1 Pa
    IMPEDANCE: 250 ohms
    MAXIMUM INPUT SOUND LEVEL: 145 dB SPL, 1 kHz at 1% T.H.D.
    DYNAMIC RANGE (typical): 115 dB, 1 kHz at Max SPL
    SIGNAL-TO-NOISE RATIO: 64 dB, 1 kHz at 1 Pa
    PHANTOM POWER REQUIREMENTS: 11-52V DC, 2 mA typical
    SWITCH: Flat, roll-off
    WEIGHT (MICROPHONE): 0.3 oz (8 g)
    WEIGHT (POWER MODULE): 2.9 oz (81 g)
    DIMENSIONS (MICROPHONE): 0.98" (25.0 mm) long,
    0.40" (10.2 mm) diameter
    DIMENSIONS (POWER MODULE): 3.66" (92.9 mm) long,
    0.74" (18.9 mm) diameter
    OUTPUT CONNECTOR (POWER MODULE): Integral 3-pin XLRM-type
    CABLE 6.0' (1.8 m) long (permanently attached to microphone), 0.10" (2.6 mm) diameter, 2-conductor, shielded cable with TA3F-type connector
    ACCESSORIES FURNISHED: AT8418 UniMount® microphone instrument mount; AT8538 power module; soft protective pouch